Watertight joint profiles


  • high load-bearing capacity
  • replaceable expansion insert


watertight, resistant to heavy loads, trafficable by fork-lift trucks, expansion insert can be replaced in the event of damage without damaging the adjacent covering, abrasion-, weather- and temperature-resistant (-40°C to +120°C), resistant to de-icing salt and waste water (alkalis, microbes, bacteria), a different sealing membrane can be used by arrangement


parking decks, parking garages, underground garages, ramp crossings, pedestrian bridges


substructure hot-dip galvanised steel and visible surface stainless steel V2A (V4A on request), EPDM expansion insert, Wolfin IB sealing membrane

Covering Types

coating, concrete, screed, industrial coverings, natural and stone slabs


passenger cars, trucks, fork-lifts

Formed parts

upstand, end piece, corner piece, T-piece, cross piece, floor-wall connections


The sealing and expansion insert is flanged with screws M10 at intervals of 150 mm.

An approx. 5 mm wide grouting joint must be installed on site between the joint profile and the covering to prevent water infiltration from the sides.

At profile height 45 mm and 59 mm, a minimum joint width of 80 mm is required.

Installation by our own fitters recommended.

Technical data

Movement horizontal:
100 mm (-40/+60 mm)
Movement vertical:
50 mm (±25 mm)
Visible width:
196 mm
Maximal joint width:
100 mm
Load rating trucks:
300 kN (DIN 1072)
Load rating forklifts:
50 kN (DIN 1055-3)
Supply length:
3 mtr
Color of expansion insert:


Article No. Profile height (h) Recess (BxT)
VA.8.196/45 45 mm 380 x 55 mm
VA.8.196/59 59 mm 380 x 69 mm
VA.8.196/74 74 mm 380 x 84 mm
VA.8.196/89 89 mm 380 x 99 mm
VA.8.196/104 104 mm 380 x 114 mm
VA.8.196/119 119 mm 380 x 129 mm
VA.8.196/150 150 mm 380 x 160 mm

Special heights on request.

Technical design
Subject to technical change without notice